Replacing Transmission / Clutch Lubricant - Cobra 2005 King Owner's Manual

Replacing Transmission / Clutch Lubricant

Tools needed:
• 235 ml (8.0 oz) Cobra Venom 3 Shoe Clutch Milk (Part # MCMUGF01).
• 13 mm combination wrench
Procedure:
1. Begin this procedure with a bike that has been ridden more than 5 minutes
but less than 10 minutes. It is desired to have the engine warm enough so
that the oil is 'runny' but not so hot that there is risk of being burned by the
engine or the oil.
Hot oil and hot components on the motorcycle may cause burns.
2. Lean bike against something or set on stand with oil drain hole.
3. Using a 13 mm wrench, remove the oil drain bolt located on the right side of
the engine, on the clutch cover, near the brake lever (Item 2, figure 1).
4. After it has drained, reinstall the bolt being sure that the copper gasket is in
place. Torque to 15 Nm (11 ft-lb).
5. Reapply oil from oil fill plug 235 cc (8.0 oz) Cobra Venom 3 Shoe Clutch Milk
thru the oil fill plug.
NOTE:
Lean bike over onto it's left hand side so that the clutch cover is up unless you
have a squeeze bottle.
6. Reapply the oil fill plug, hand tight, being sure the fiber gasket is in place.
CAUTION:
Cobra has spent considerable time and money developing the proper lubrication
to handle the harsh environment of the automatic clutch and transmission of this
motorcycle. Cobra's specially developed Cobra Venom 3 Shoe Clutch Milk (Part
# MCMUGF01) was formulated to provide superior lubrication and cooling
Figure 1
12