M3: Front Brake Adjustment - Cobra PW3 2003 Owner's Service Manual

M3: Front brake adjustment

Tools recommended for front brake maintenance:
• 10mm open end wrench
Figure 4, from the brake lever
From the brake lever:
1. Loosen the locking nut on the brake lever.
2. Adjust the bolt to desirable position.
3. Tighten the locking nut.
From the brake hub:
1. Loosen the 10mm nut on the hub.
2. Adjust the brake cable to desirable position
3. Tighten the 10mm nut.
CAUTION:
If you tighten the front brake up too much, the brakes may hang up causing the
brake pads to wear incorrectly and prematurely.
3. If the chain requires adjusting, loosen the axel
with a pair of 19 mm wrenches and tighten the
chain by rotating the adjuster bolts clockwise
(CW) or loosen the chain by rotating the adjuster
bolts (CCW).
4. Retighten the axel bolt to 25 ft-lb (34 Nm).
Figure 3
Figure 5, from the brake hub
13