Creating, Deleting, And Resetting Raid Sets; Creating A Raid Volume - Asus P4P800 SE User Manual

5.6.3 Creating, Deleting, and Resetting RAID Sets

The Serial ATA RAID set must be configured in the RAID Configuration
utility. This configuration can be done by the Intel
During the Power-On Self Test (POST), the following message will appear
for a few seconds: "Press <Ctrl-I> to enter Raid Configuration Utility".
When this message appears, press <Ctrl+I> to launch the RAID
configuration utility.
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
RAID Volumes:
None defined.
Non-RAID Disks:
Port Drive Model
0 ST380013AS
1 ST380013AS

5.6.4 Creating a RAID Volume

To create a RAID volume:
1. Select 1. Create RAID Volume and press <Enter> . The following
screen appears.
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
Enter a string between 1 and 16 characters in length taht can be used
to uniquely identify the RAID volume. This name is case sensitive and
[ [
5-18
[
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[
DISK/VOLUME INFORMATION
Serial #
xxxxxxxx
xxxxxxxx
[ [ ]-Select ]-Select [ESC] Exit [ESC] Exit
[ CREATE ARRAY MENU
Name:
RAID Level:
Strip Size:
Capacity:
can not contain special characters.
]-Change ]-Change [TAB]-Next [TAB]-Next
® RAID Option ROM.
MAIN MENU ]
]
Size Status
Normal
74.5GB
Normal
74.5GB
[Enter]-Select Menu [Enter]-Select Menu
]
RAID_Volume1
RAID0(Stripe)
128KB
149.0GB
Create Volume
[ HELP ]
[ESC] Previous Menu [ESC] Previous Menu [Enter]-Select [Enter]-Select
Chapter 5: Software support
Bootable
Yes
Yes