Install Vermiculite, Embers And Logs - Superior DRT40ST40DMN Installation And Operation Instructions Manual

Innovative Hearth Products
DRT40 Multi View Series Direct Vent Gas Fireplace
INSTALLATION STEPS:
READ WARNINGS ON THIS PAGE BEFORE PROCEEDING. FOLLOW THE
LOG PLACEMENT INSTRUCTIONS EXACTLY
1. Remove the Front Face Assembly with Barrier, front glass enclosure
panel (see Glass Enclosure Panel Removal and Installation Instruc-
tions, Page 9 ).
2. Remove the following from firebox; log set, bag of embers and bag
of vermiculite. Handle logs carefully to prevent breakage.
3. Ensure the Grate is properly installed in the firebox with the 4 legs
of the grate fitting into the 4 dimples on the firebox floor.
4. Placement of Glowing Embers -
Separate the Embers (rockwool) into pieces about the size of a quarter
(see Figure 77). Keep the pieces fluffed up, not matted. Distribute
these pieces over the surface of the burner, as shown in Figure 78.
Do not use more than is necessary. Ensure that the main burner ports
remain uncovered by the ember material.
5. Place Lava Rock - Spread lava rock evenly over firebox floor.
6. Install Vermiculite - Place some vermiculite on the firebox floor
around the grate (the entire bag of vermiculite will NOT be used). See
Figure 6. DO NOT PLACE ANY VERMICULITE ON THE BURNER.
Note: This appliance is provided with enough Glowing Embers for several
applications, do not use all that is in a new bag at one time. For best
glowing effect, replace the ember material annually. Replacement Glowing
Embers are available (order Catalog Number 88l53).
Figure 77
Figure 78
50
Glowing Embers
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
REFERENCE
Firebox Accessories / Parts
Cat. No. Model No.
88L53 FGE Bag of Glowing Embers
80L42 FDVS Bag of Decorative Volcanic Stone
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas
line connected and tested for leaks and the initial
burner operation has been checked out.
• The size and position of the log set wasengineered
to give the appliance a safe, reliable and attrac-
tive flame pattern. Any attempt to use a different
log set in the fireplace will void the warranty and
will result in incomplete combustion, sooting,
and poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install grate,volcanicstone,
vermiculite, embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage
to the appliance and prove hazardous to your
safety.
• If logs are not installed according to the log
installation instructions, flame impingement
and improper combustion could occur and result
in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic gas.
Installation and Operation Instructions
900299-00, 08/2015
Description