Table of Contents
Advertisement
Innovative Hearth Products
BRT40ST See-Through B-Vent Gas Fireplaces
INSTALL VERMICULITE, GLOWING EMBERS AND LOGS
NOTE: It is important to ensure proper log placement per the manual
when installing these units. Verify pilot flame is not obstructed. See
Verifying Appliance Operation on Page 17.
NOTE: Turn off all electricity to the appliance before you install vermiculite,
embers and logs. DO NOT attempt to install the logs until the appliance
installation has been completed, the gas line connected and tested for
leaks and the initial burner operation has been checked out.
INSTALLATION STEPS:
READ WARNINGS ON THIS PAGE BEFORE PROCEEDING. FOLLOW THE
LOG PLACEMENT INSTRUCTIONS EXACTLY
1. Remove the front glass enclosure panel (see Glass Enclosure Panel
Removal and Installation Instructions, Page 35).
2. Remove the following from firebox; log set, bag of embers and bag
of vermiculite. Handle logs carefully to prevent breakage.
3. Ensure the Grate is properly installed in the firebox with the 4 legs
of the grate fitting into the 4 dimples on the firebox floor.
4. Placement of Glowing Embers -
Separate the Embers (rockwool) into pieces about the size of a quarter
(see Figure 39). Keep the pieces fluffed up, not matted. Distribute
these pieces over the surface of the burner, as shown in Figure 40.
Do not use more than is necessary. Ensure that the main burner ports
remain uncovered by the ember material.
5. Place Volcanic Stone - Spread volcanic stone evenly over firebox
floor.
6. Install Vermiculite - Place some vermiculite on the firebox floor
around the grate (the entire bag of vermiculite will NOT be used). DO
NOT PLACE ANY VERMICULITE ON THE BURNER.
NOTE: This appliance is provided with enough Glowing Embers for
several applications, do not use all that is in a new bag at one time. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (order Catalog Number 88L53).
Figure 39
Firebox Accessories / Parts
Cat. No.
Model No.
88L53
80L42
FDVS
H6319
36
REFERENCE
Description
FGE
Bag of Glowing Embers
Bag of Decorative Volcanic Stone
----
Bag of Vermiculite
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Glowing Embers
Figure 40
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas
line connected and tested for leaks and the initial
burner operation has been checked out.
• The size and position of the log set was engineered
to give the appliance a safe, reliable and attractive
flame pattern. Any attempt to use a different log
set in the fireplace will void the warranty and will
result in incomplete combustion, sooting, and
poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install grate, volcanic stone,
vermiculite, embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement
and improper combustion could occur and result
in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic gas.
Operation
900301-00 05/2016
Advertisement
Table of Contents
