Miele DA211 Operating And Installation Instructions page 32

Installation
Retaining plate A
1
^ Drill two
/ " (3 mm) holes, one at S +
8
4" (100 mm) and one at S + 16
(425 mm) on the center line for the
retaining plate (see "Appliance
dimensions").
^ Lightly secure retaining plate A into
position using 5 x 40 mm screws
through the two holes and use the
notches to align with the center line.
32
3
/ "
4
^ Drill 4 more
the now fitted retaining plate.
^ Screw two 5 x 40 mm screws into the
upper two holes.
Retaining plate B
^ Hold retaining plate B to the wall and
push up until it is directly below the
ceiling. Use the notches and the
center line to align it horizontally.
Mark the 2 drill holes on the wall.
^ Drill two
wall.
^ Secure the retaining plate with two
5 x 40 mm screws.
1
/ " (3 mm) holes through
8
1
/ " (3 mm) holes into the
8