Table of Contents
Advertisement
2.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There
are three connectors on each Ultra DMA 133/100 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard's IDE connector,
then select one of the following modes to configure your device.
P5E WS PRO
P5E WS Professional IDE connector
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
3-12
®
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on
the Ultra ATA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
–
Use the 80
conductor IDE cable for Ultra ATA 100/66/33 IDE devices.
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Mode of
device(s)
-
Master
Slave
Master
Slave
Chapter 3: Motherboard information
Cable connector
Black
Black
Gray
Black or gray
Advertisement
Table of Contents
