2.9
Connecting cables
The TW300-E5/PI4 chassis includes the power and signal cables that you need to
connect to the motherboard, storage drives, and other devices that you intend to
install.
•
•
Standard cables connected to the motherboard
1.
24-pin ATX 12V power plug
2.
4-pin ATX 12V power plug
3.
Card Reader cable
4.
Front panel USB 2.0 cable
2-26
The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
Refer to Chapter 3 for detailed information on the connectors.
2
8
3 4
1
5
6
7
5.
IDE signal cable
6.
Serial ATA signal cables
7.
System panel cable
8.
System fan cable
Chapter 2: Hardware setup