Voltage Selector - Asus Terminator 2 Barebone System T2-P User Manual

Power supply unit plugs
6. Connect the 4-pin power plug to the power connector of the floppy
disk drive.
7. Connect the 4-pin power plug(s) to the power connector of the optical
drive(s).
8. Connect the 4-pin power plug to the power connector of the hard disk
drive.

Voltage selector

The PSU has a 115V/230V voltage selector
switch located beside the power connector. Use
this switch to select the appropriate system input
voltage according to the voltage supply in your
area.
If the voltage supply in your area is 100-127V,
set the switch to 115V.
If the voltage supply in your area is 200-240V,
set the switch to 230V.
Setting the switch to 115V in a 230V environment will seriously
damage the system!
40
7
1
6
1
230
Chapter 2: Basic installation
8