Pride Mobility LEGEND Owner's Manual page 14

Main Circuit Breaker
When the voltage in your Scooter’s batteries becomes low or your Scooter is heavily strained because of exces-
sive loads, the main circuit breaker may trip to protect your Scooter’s motor and electronics from damage. When
your Scooter’s main circuit breaker trips, the reset button pops out and your Scooter shuts down. If this occurs,
perform the following steps.
1. Allow a minute or so for your Scooter’s electronics to “rest.”
2. Push in the reset button to reset the circuit breaker.
Rear Storage Compartment
This compartment is for storing the charger power cord.
Manual Freewheel Lever
Whenever you want to push your Scooter for short distances, you can put it in manual freewheel mode.
WARNING! It is important to remember that when your Scooter is in manual freewheel mode, the
braking system is disengaged. Even though the motor is disengaged from the drive system when
your Scooter is put in manual freewheel mode, the motor can still run if the throttle lever is pushed.
Follow these safety rules when using the manual freewheel mode:
n
Do not disengage the drive motors when your Scooter is on an incline; the Scooter could roll
down on its own and cause injury.
n
Before placing your Scooter into or taking it out of manual freewheel mode, ensure the key is
removed from the key switch.
n
Never sit on your Scooter when it is in manual freewheel mode.
n
When you have finished pushing your Scooter, always return it to the drive mode to lock the
brakes.
n The manual freewheel lever is located on the end of the motor/transaxle assembly at the right rear of the
Scooter. See figure 8.
n Pull up on the manual freewheel lever to disable the drive system and the brake system; you will then be
able to push your Scooter.
n Push down on the manual freewheel lever to reengage the drive and brake systems, and take your Scooter
out of manual freewheel mode.
Charger Power Cord Receptacle
This receptacle enables you to plug the charger power cord into the Scooter. For further details on using the
charger power cord, refer to V. “Batteries and Charging.”
Motor/Transaxle Assembly
The motor/transaxle assembly is an electromechanical unit that converts electricity from the batteries into con-
trolled mechanical energy that drives the Scooter’s wheels.
Ammeter
When the battery charger is plugged into a wall outlet, the ammeter indicates the charging status of your Scooter’s
batteries.
n When your Scooter’s batteries are fully charged, the amperage reading is at or near zero (0) amps.
14
I V . D E S C R I P T I O N
Legend