Select Event-Based Air Cleaning Setting; Reset Service Reminder Messages; Set Time And Day; Understanding Program Schedules - Aprilaire 8810 Owner's Manual

OPERATION & PROGRAMMING
SELECT EVENT-BASED ™ AIR CLEANING
SETTING
Press to select:
ON-24/7: This option will provide the maximum amount
of air cleaning available . The air cleaner will be active
for 24 hours a day seven days a week .
AUTO: Air cleaning will not occur for the sole purpose
of air cleaning, but will occur during fan operation for
heating and cooling .
8
CIRC-30/HR: The air cleaner will run a minimum of
30 minutes every hour . The air cleaner will monitor
the amount of time your heating and cooling system
runs; if 30 minutes is not reached the air cleaner will
automatically turn on . This will maximize the amount of
air cleaning while minimizing energy consumption .
EVENT-3HR: When selected, the air cleaner will run
continuously and then return to the most recent mode
of AUTO, CIRC-30/HR, or ON-24/7 . Use this option
when the air needs cleaning; an example would be
while vacuuming .
ALLERGY-24HR: When seasonal allergies spike and
outside air quality is at its worst, choose this option .
Your air cleaner will run continuously for 24 hours and
then return to the most recent mode of AUTO,
CIRC-30/HR, or ON-24/7 .

RESET SERVICE REMINDER MESSAGES

Press and hold and together for three
seconds to reset a service reminder message .
OPERATION & PROGRAMMING

SET TIME AND DAY

1 . Press to enter time setting mode . The hour
is flashing .
2 . Press or to adjust the hour .
3 . Press , the minutes flash . Press
to adjust the minutes .
4 . Press , the day flashes . Press
or
to adjust day .
5 . Press
to end . "DONE" will display .
The thermostat will return to normal mode if no key is
pressed within 3 seconds .
Note: If configured to do so, the home automation
system can send periodic time updates to the thermostat .
If the thermostat is configured to be used with an
Aprilaire account the thermostat's time and date will be
updated periodically, and will update automatically for
daylight savings .

UNDERSTANDING PROGRAM SCHEDULES

The daily schedule is split into four sections:
WAKE: 6am-8am – Temperature you would prefer to
wake up to, until you leave for the day .
LEAVE: 8am-5pm – Temperature when you are away
or
from the house during the day .
RETURN: 5pm-10pm – Temperature you would prefer to
return to, until bedtime .
SLEEP: 10pm-6am – Temperature you would prefer
during the night .
The times shown are the defaults . The start time and
temperature of each section can be changed to fit your
schedule (see page 11) .
9