Controls & Display Overview; Wi-Fi Setup - Aprilaire 8810 Owner's Manual

ABOUT YOUR NEW THERMOSTAT
CONTROLS & DISPLAY OVERVIEW
CURRENT INDOOR TEMPERATURE
SYSTEM MODE
SETTING
CLEAN AIR
SETTING
SYSTEM MODE
CLEAN AIR
PROGRAM
Includes Event-Based
COVER
CURRENT SCHEDULE PERIOD MESSAGE CENTER
NOTE: BACKLIGHT IS ACTIVATED WITH FIRST BUTTON PRESS AND AUTOMATICALLY TURNS OFF .
4
CURRENT TIME OUTDOOR TEMPERATURE (OPTIONAL)
TEMPERATURE SETTING
EQUIPMENT STATUS
UP
DOWN
HOLD
INDICATORS SHOW THROUGH HOUSING
HEAT PUMP ONLY
EMERGENCY HEAT OR
Air Cleaning
™
AUXILIARY HEAT (RED)
SYSTEM FAULT (YELLOW)
MAINTENANCE REMINDER
(YELLOW FLASHING)
QUICK REFERENCE CARD
WI-FI SIGNAL STRENGTH

WI-FI SETUP

To connect the 8810 thermostat to a Wi-Fi network follow the steps below .
Note: You will need a computer or mobile device with Wi-Fi and a web browser .
STEP 1
Verify the thermostat is in
Wi-Fi Connection Mode.
The thermostat by default will be in Wi-Fi Connection
Mode . To confirm that the thermostat is in Wi-Fi
Connection Mode, verify that the radio bars on the
thermostat are strobing as shown below .
Note: If the thermostat is not in Wi-Fi Connection
Mode, refer to Clearing Router Settings on page 15 .
STEP 2
Connect to the thermostat using a
computer or mobile device.
On your computer or mobile device, scan for
available networks . The thermostat should appear
as APRILAIRE8810 followed by a unique identifier,
corresponding to the last 6 digits of the MAC address .
Connect to the thermostat you want to configure .
If you are installing multiple thermostats, you can
determine the MAC address of the specific thermostat
you are trying to configure by removing the cover on the
front of the thermostat to access the MAC address label .
(Continued on the following page.)
5