3Com 400 Family Configuration Manual page 205

Table 216 Setting the Maximum Times of Real-time Accounting Request Failing to be
Responded
Operation
Set maximum times of real-time accounting
request failing to be responded
Restore the maximum times to the default value undo retry realtime-accounting
How to calculate the value of
connection will timeout in T and the real-time accounting interval of NAS is t, then
the integer part of the result from dividing T by t is the value of
when applied, it is suggested that T should be a number that can be divided
exactly by t.
By default, the real-time accounting request can fail to be responded to no more
than 5 times.
Enabling/Disabling the Stopping Accounting Request Buffer
Because the stopping accounting request concerns the account balance and will
affect the amount of charge, which is very important for both the subscribers and
the ISP, NAS shall make its best effort to send the message to the RADIUS
accounting server. If the message from the Switch to the RADIUS accounting
server has not been responded to, the Switch will save it in the local buffer and
retransmit it until the server responds or discards the messages after transmitting
for the specified number of times. The following command can be used for setting
to save the message or not.
Perform the following configurations in RADIUS Scheme View.
Table 217 Enabling/Disabling the Stopping Accounting Request Buffer
Operation
Enable stopping accounting request buffer stop-accounting-buffer enable
Disable stopping accounting request buffer undo stop-accounting-buffer enable
By default, the stopping accounting request will be saved in the buffer.
Setting the Maximum Retransmitting Times of Stopping Accounting
Request
Use this command to set the maximum number of retransmission times that the
Switch will attempt to retransmit the saved message from its local buffer.
Perform the following configurations in RADIUS Scheme View.
Table 218 Setting the Maximum Retransmitting Times of Stopping Accounting Request
Operation
Set the maximum retransmitting times of stopping
accounting request
Restore the maximum retransmitting times of
stopping accounting request to the default value
By default, the stopping accounting request can be retransmitted up to 500 times.
Enabling the Selection of the Radius Accounting Option
Perform the following configurations in RADIUS Scheme View.
AAA and RADIUS Protocol Configuration
Command
retry realtime-accounting
retry_times
? Suppose that RADIUS server
retry-times
Command
Command
retry stop-accounting
retry_times
undo retry
stop-accounting
203
. Therefore,
count