Ccr Tree Setup And Changes - Nortel BCM 50/400 Administration Manual

CCR Tree Setup and Changes

Making changes to a CCR Tree involves
Disabling
1. the Tree
Making Changes
2.
Saving
3. the Changes
Re-Enabling
4. the Tree
Disable the Tree:
1.
Feature 983
1. Press
2. Enter Log Code:
3. Enter Password:
AA
4. Press
Table
5. Press
Next
6. Press until you see:
Chng
7. Press , then
* *
8. Press (will skip you to step 3 of next instructions) or Press
Make Changes to the Tree:
2.
Feature 983
1. Press
2. Enter Log Code:
3. Enter Password:
Othr
4. Press , press
Tree Number Number
5. Enter
Chng
6. Press
Path Number
7. Enter the
Note: Path 0
is where you record the menu options (which plays immediately after the introduction
greeting (recorded on page 5))
Example:

Path 0

For "store and service hours", press 1.
 For "our company directory", press 2
 For "Sales", press 3
 For

For
 For all other inquiries, press 0

Path 1
 Our regular business hours are
 We are located at
 Our fax number is
 Please visit us online at www
to the Tree
Important N : You MUST save tree before exiting the system
OTE
738662 Ok
, press
266344
1 OK
, enter , press twice
CCR Tree 1
Disable
738662 Ok
, press
266344
CCR Admin
, press
(usually 1 if only using one tree)
you want to change, then press
Rec
: Press and then
(goes to Path 3)
, press 4
, press 5
Info, Rec
: Press press
4 steps:
(or 2 depending on how many trees you are using)
OK
Rec
again
(goes to Path 1)
(goes to Path 2)
(goes to Path 4)
(goes to Path 5)
Rls
to exit programming
, OK
press
(see below)
Service:
Email:
Page 6 of 8
604 -856- 9155
service@natg.ca