Chevrolet Chevy Cruze Limited 2016 Owner's Manual page 279

278 Vehicle Care
20. Dispose of the used sealant
canister (2) and sealant/air
hose (7) assembly at a local
dealer or in accordance with
local state codes and practices.
21. Replace it with a new canister
available from your dealer.
22. After temporarily sealing a tire
using the tire sealant and
compressor kit, take the
vehicle to an authorized dealer
within 161 km (100 mi) of
driving to have the tire repaired
or replaced.
Using the Tire Sealant and
Compressor Kit without
Sealant to Inflate a Tire (Not
Punctured)
To use the air compressor to inflate
a tire with air only and not sealant:
If a tire goes flat, avoid further tire
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See Hazard
Warning Flashers 0 129.
See If a Tire Goes Flat 0 272 for
other important safety warnings.
1. Remove the tire sealant and
compressor kit from its storage
location. See Storing the Tire
Sealant and Compressor Kit
0 280.
2. Unlock the air only hose (6)
from the sealant canister (2) by
pulling up on the lever.
3. Pull the air only hose (6) from
the sealant canister (2).
4. Remove the power plug (3)
from the air compressor (1).
5. Place the kit on the ground.
Make sure the tire valve stem
is positioned close to the
ground so the hose will
reach it.
6. Remove the tire valve stem
cap by turning it
counterclockwise.
7. Attach the air only hose (6)
onto the tire valve stem and
press the lever down to
secure it.