Table of Contents
Advertisement
LAN Enable/Disable
Use JPL1 and JPL2 to enable/disable
LAN ports 1/2. See the table on the
right for jumper settings. The default
setting is Enabled.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
BMC Enable
Jumper JPBR1 allows you to enable
the embedded the BMC (Baseboard
Management Controller) to provide
IPMI 2.0/KVM support. See the table
on the right for jumper settings.
SMB Bus to PCIe Slots
Use jumpers JI
C1 and JI
2
nect the System Management Bus
(I
C) to PCI-Express slots in order to
2
improve PCIe slot performance. These
two jumpers are to be set at the same
time. The default setting is Closed to
enable the connections. See the table
on the right for jumper settings.
PCI-E Slot SMB Enable (I
Use jumpers I
C1/I
2
2
SMB (System Management Bus) sup-
port to improve system management
for the PCI-E slots. See the table on
the right for jumper settings.
C2 to con-
2
C1/I
C2)
2
2
C2 to enable PCI-E
5-21
Chapter 5: Advanced Serverboard Setup
LAN1/2 Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
BMC Enable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
I
C to PCIe
2
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
PCI-E Slot SMB Enable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Enabled
Disabled
Definition
Enabled
Disabled
Definition
BMC Enabled
Disabled
Definition
Enabled
Disabled
Definition
Enabled
Disabled
Advertisement
Table of Contents
