Maintenance; Environmental Protection; Technical Specifications - Metabo SBE 610 Original Instructions Manual

7.8 Tool change with a geared chuck (10)
(equipment-dependent)
See illustrations, page 3.
Clamping tool:
Insert the tool and use the chuck key (11) to
uniformly clamp tight in all 3 bores.
Removing tool:
Open the geared chuck (10) with chuck key (11)
and remove tool.
7.9 Removing the chuck
Undo the locking screw. Caution left-handed
thread!
Hold the drill spindle firmly with an open-ended
spanner. With a light blow from a rubber hammer,
release the chuck from the clamped hexagon
spanner and unscrew it.

8. Maintenance

Keyless chuck cleaning:
After prolonged use hold the chuck vertically, with
the opening facing down, and fully open and close it
several times. The dust collected falls from the
opening. Regular use of cleaning spray on the jaws
and jaw openings is recommended.
f
9. Accessories
Use only genuine Metabo accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating instruc-
tions.
Fit accessories securely. Secure the machine if it is
operated in a bracket. Loss of control can cause
personal injury.
See page 4.
A Angle drilling and screwdriving attachment
B Flexible shaft
C Drill stand
D Machine vice
E Scaffolding hook with integrated bit depot:
Clip into the scaffolding hook fastening (6) and
turn to engage in one of the 4 positions.
F Steel wire end brush
G Steel wire cup brush
H Steel wire rotary brush
I Bit clamping bush
For complete range of accessories, see
www.metabo.com or the main catalogue.
10. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

11. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric
equipment and its implementation in national legal
systems, used power tools must be collected
separately and handed in for environmentally
compatible recycling.

12. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P = Nominal power input
1
P = Power output
2
n = No load speed
0
n = Speed at rated load
1
s max. = Max. impact rate
ø max. = Max. solid drill diameter
b = Chuck capacity
G = Drill spindle thread
H = Drill spindle with hexagon socket
m = Weight without mains cable
D = Collar diameter
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the emis-
sions from this power tool and compare these with
the values emitted by other power tools. The actual
values may be higher or lower, depending on the
particular application and the condition of the tool or
ENGLISH en
11