Asus Motherboard DSBF-DE User Manual page 49

2. LAN controller setting (3-pin LAN_EN1)
This jumper allows you to enable or disable the onboard Intel
LAN controller. Set to pins 1-2 to activate the Gigabit LAN feature.
DSBF-DE Series LAN1_EN setting
3. USB device wake-up (3-pin USBPW12, USBPW34)
Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU
stopped, DRAM refreshed, system running in low power mode) using the
connected USB devices. Set to +5VSB to wake up from S4 sleep mode (no
power to CPU, DRAM, power supply in reduced power mode).
DSBF-DE Series USB device wake up
• The USB device wake-up feature requires a power supply that can provide
500mA on the +5VSB lead for each USB port; otherwise, the system will
not power up.
• If you are using Windows
up the system from S4 sleep mode.
• The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal condition or in sleep mode.
ASUS DSBF-DE Series
LAN1_EN1
2 1 3 2
Enable Disable
(Default)
USBPW12
1 2
+5V +5VSB
(Default)
USBPW34
2 1 3 2
+5V +5VSB
(Default)
®
2000, you need to install Service Pack 4 to wake
®
6321 Gigabit
2 3
-