Self-Clean Pyrolytic Cycle - Fisher & Paykel Titan Aerotech OD302US Service Manual

Service Manual 546596A: 302 Series Titan Oven

2.32 Self-Clean Pyrolytic Cycle

Duration:
Pyro Temp:
Heat-up time:
Holding time:
Cool-down time:
If a Self-Clean Cycle will not start, check that there are no meat probes inserted and that
the control knobs of the cavity not being cleaned (in a double oven) are in the 'OFF'
position.
The oven self-clean mode operates by heating the oven to a temperature of
approximately 885°F (473°C). This burns off and breaks down soil and grease deposits.
The ash residue that remains can simply be removed from the cool oven with a damp
cloth or sponge. The self-clean cycle normally takes about three hours.
To start a Self-Clean Cycle
1. Turn the oven mode dial until 'Self Clean' appears in the display.
2. Select the maximum temperature using the temperature dial.
'000' will appear in the temperature display. This will change to
cycle begins.
'Door Lock' and 'Clean' will show in the clock display.
The door lock will automatically activate once the Self-Clean mode and maximum
temperature have been selected.
A countdown of minutes remaining will be shown in the clock display.
The Broil / Grill inner element, the throat element, the smoke eliminator element and the
vent fan operate during the Self-Clean Cycle. Additionally, during the first fifteen seconds
of each minute the bake element is on and during the third fifteen seconds of each
minute the Broil / Grill outer element is on.
The cooling fan for the cavity being cleaned will be on high speed. The cooling fan for
the other cavity will be on low speed.
During the Self-Clean Cycle in a double oven, the cavity not being cleaned cannot be
operated in any mode.
The oven heats to its cleaning temperature of 885°F (473°C) and maintains this
temperature until approximately 2½ hours into the cycle.
The elements then turn off and the cool down period commences.
temperature reduces to 356°F (180°C) the door will unlock and the 'Door Lock' display
will disappear from the clock display.
When the self-clean cycle has finished, 'Clean' and '00:00' will flash in the clock display
until it is returned to manual operation. Press the PUSH TO CLEAR button and turn the
oven mode and temperature dials to the OFF position to do this.
At the completion of the self-clean cycle, there may be grey ash deposited on the inside
of the oven. The amount of ash is dependent on the amount of soil in the oven before
cleaning. To remove the ash, wait until the oven has completely cooled. The bulk of the
ash is easily removed with a small brush or dry cloth, then wiped over with a damp cloth.
The self-clean mode can be cancelled at any time by turning the oven dials to 'OFF'.
'Clean End' will appear in the oven mode display but if the oven temperature has already
reached 482°F (250°C) the door lock will remain activated until the oven cools to 356°F
(180°C).
3hrs
925°F (500°C)
50 minutes approx.
100 minutes approx.
30 minutes
20
June 2005
when the
When the