Manual instruction | Electric screwdriver
Safety regulations for the use
This model row of the electric screwdriver is intended
for screwing, this machine is also suitable for drilling
in wood, metal, ceramic and plastic. Machines with
electronic control and right/left rotation are also
suitable for thread cutting.
The following listed safety instructions should serve
you for the right use and for the protection of your
own safety. Therefore please read this very carefully.
When passing this device over to a third person,
these instructions must be handed out, too.
Please, read and take note of the following
comments that regard your protection against
electric shock and risk of injury and fire:
•
Verify that the power supply in your area is
compatible with the voltage listed on the machine
•
Check
the
electric
connections for any damage
•
Connect the power lead to the mains only with
the tool turned off
•
Always turn on the tool before setting it against
the piece you are working on
•
Adopt protective measures against electric
shock. Avoid body contact with earthed parts,
such as metal pipes, radiators, cooking ranges,
refrigerators and the like
•
Large variations in temperature can lead to
condensation on live part. Before use: Give the
machine time to adjust to the temperature of the
work area
•
Do not use machines, tools and recommended
accessories for works other than those for which
they are designed!
•
Secure the workpiece. Use clamping devices or a
vise to hold the workpieces securely
•
To avoid accidents, do not wear jewelry or loose
clothing that could be caught up by moving parts.
It is recommended to wear protective footwear and
gloves. Long hair should be tied up
•
When dust, splinters or shavings area problem
while working, or when working overhead, please,
wear protective eyewear and, if necessary, a
protective mask
•
In the case of loud noise, wear earprotection
•
Be sure you always have safe footing, when
working on floors, ladders and scaffoldings
•
Keep electric tools away from humidity and rain.
Do not immerse
•
When working outdoors, only use approved
tools and extension cables marked for outdoor use
•
Do not use the equipment in areas where danger
EN
tools
and
electrical
of explosion exists
•
Only have repairs done by specialists using
original parts
WARNING: The consumption of alcohol,
medication and drugs, plus states of
illness, fever and fatigue will affect your
ability to react. Do not use electric tools
in any of these situations.
•
Keep electric tools away from children
•
Store electric tools in the original box in a safe
place and out of the reach of children
•
When not in use, during breaks, when doing
adjustment works, changing accessories or during
repair, always unplug the cable
•
Never carry the tool by the cable. Never unplug
the tool by pulling on the cable
•
When working: Do not allow the motor to stall
under load
•
Keep your workplace tidy: untidiness can cause
accidents!
•
Avoid abnormal body postures while working
•
Avoid switching on or starting up the machine
unintentionally
•
Do not leave keys, spanners and adjusting tools
inserted in the machine.
•
Before drilling holes or screwing into a wall, in
case of doubt, check with a metal/voltage detector
that you are not breaking into electricity, gas or
water supply line
•
Before you lay down the electric screwdriver
make sure that all moving parts have come to a
stop.
Keyless chuck
These machines are equipped with a tightening
chuck for a drill. Thus, you can manually change the
accessories quickly and without using a key.
To unblock the lock:
•
for
this
purpose
move
the
coupling
in the rear part of the
chuck (5) back until it
clicks.
•
Rotate front part
of the chuck (5) and
arrange the jaws in
the distance necessary
for
installation
replacement
of
accessories.
4
/
the