TP-Link NC230 User Manual page 29

 Fallback IP: If the camera cannot get a Dynamic IP address from a DHCP server within
limited tries, the camera will assign a default IP address, 192.168.0.10, by itself as the
Fallback IP address.
 Static IP: Select this option when a static or fixed IP address is obtained for the camera. A
static IP address will ease your access to the camera in the future. Add your camera's static
IP information to your router to avoid IP conflicts.
 MAC Address: Displays the Ethernet MAC address of the camera. The MAC address is
read-only.
 IP Address: Enter a fixed IP address for the camera in dotted-decimal notation.
 Subnet Mask: Enter the subnet mask in dotted-decimal notation. The default value is
"255.255.255.0."
 Default Gateway: Enter the default gateway in dotted-decimal notation.
 Primary DNS Server: Enter a DNS address in dotted-decimal notation.
 Secondary DNS Server: Enter a DNS address in dotted-decimal notation.
PPPoE (Point to Point Protocol over Ethernet)
This camera is a PPPoE enabled one. It can directly connect to the xDSL, however, it should be
set up in a LAN environment to configure the PPPoE information first, and then connect to the
xDSL modem. Power on again, and the camera will dial on to the ISP to get a dynamic IP address
and connect to the WAN through the xDSL modem. In this case, you need to use a domain name
to log in to the camera. For details, please refer to
NC230 HD Day/Night Wi-Fi Cloud Camera
NC250 HD Day/Night Cloud Camera, 300Mbps Wi-Fi
4.4.6 Advanced >
21
DDNS.