Table of Contents
Advertisement
MICROBOARDS TECHNOLOGY, LLC
Ink Tab
The Ink Levels show how
much remains of all 3 colors,
Cyan, Magenta and Yellow.
NOTE: If you place a used
cartridge
in
the
Printer, the ink level may not be
reported correctly.
can identify the cartridge, it
may report the correct ink
levels; if not, it will assume that
the ink cartridge is new and will
show ink levels of 100%.
Before each disc is printed, the ink levels are checked. If the level of any one color is has reached
10%, a warning message will be displayed on your PC and printing will be temporarily suspended.
You can either change the cartridge at this point and click OK, or click OK to continue printing using
the same cartridge.
If you continue with the same cartridge, printing will continue uninterrupted until the ink level reaches
5%. The low ink level warning will be displayed once more. Again, either change the cartridge or
continue.
Once the ink level reaches 3% or less, the warning will be displayed before each print.
It is strongly recommended that you replace the cartridge at this point.
The Ink Cartridge information includes the re-order part number for the cartridge.
Alignment Tab
Alignment values will move the print image on the disc. Use the graphic on the right side of the tab
as a guideline in how alignment values should be adjusted.
The Resolution setting should always be set at
The Outer and Inner Diameters will
change the size of the area to be
printed.
To avoid excessive ink
buildup, these values should never
be set so that the GX Auto Printer is
printing off the media.
The default diameter settings are
1180
for the Outer and
Inner when the Resolution is at
.1mm. For hub-printable media, the
Inner diameter should be reduced.
You
may
need
alignment depending on the media
you are using (see page 13).
15
GX
Auto
If the GX
360
for the
to
adjust
the
.1mm
for best results.
GX AUTO PRINTER
Advertisement
Table of Contents
