Brady BBP 31 User Manual page 47

4
6
®
BBP 31 Sign & Label Printer User's Manual
3. Swing yellow media wiper [3] to far right (when facing display), if engaged.
4. Slide yellow media guides [4] to full-open.
5. Remove existing media, if installed, by pulling cartridge from printer. Media
unwinds from the top of the roll.
6. Insert media cartridge until spindle ends rest in slots of media holder [5].
7. Feed media from top of roll until it sits just past the black rubber roller.
8. Close media guides until they touch edge of media liner with media under the
guides.
9. Move media wiper into position so it rests on media.
Note: Not all media requires the use of the media wiper. Engage the media
wiper only if needed for the supply installed.
3
10. Close and latch ribbon cover, then close enclosure cover.
11. If printer was off, press
background and foreground colors, indicates the label dimensions and the
amount of remaining supplies.
Unpacking and Setting up Printer
. The system detects the installed supplies, sets
Setting up the Printer
5
2-7