Bluetooth Settings (For Bluetooth Interface Models Only); Pairing Using Ssp (Simple Secure Pairing) [Default] - Star Micronics FVP10 series Hardware Manual

3-7. Bluetooth Settings
RST button
LED
Pair the printer with the master device by following the procedure below.
Compatibility list: http://www.star-m.jp/prjump/000031.html

3-7-1. Pairing using SSP (Simple Secure Pairing) [Default]

(1) Working on the master device, tap [Settings] and set [Bluetooth] to ON.
(2) After turning the printer's power switch on, press and hold the PAIR button on the rear interface of the printer for 5 seconds
or more, and then release it. The LED will flash green.
(3) Pairing will be possible for 60 seconds from when the LED begins flashing green. During this time, execute "Search for
devices" from the master device and tap the relevant device from the displayed list.
Device name: Star Micronics (default)
(4) In an iOS device, after pairing, the LED will automatically begin flashing blue, and the printer will be automatically con-
nected. In an Android device, the LED turns blue only while data is sent.
(5) Connect to the printer from the master device application and perform printing. If the printing is successful, the pairing
process has been completed.
(For Bluetooth Interface Models only )
PAIR button
RST PAIR
< iOS >
<LED > Indicates the status of the Bluetooth interface.
Green (on): Not connected.
Green (flashing): Ready to start pairing.
Blue (on): Connected.
Purple (flashing): Auto connection ON.
< Android >
PAIR button
Flashing green LED
- 12 -