Bluetooth Setting (For Bluetooth Interface Model Only) - Star Micronics TSP650II SERIES Hardware Manual

3-7. Bluetooth Settings
RST button
LED
Pair the printer with the master device by following the procedure below.
3-7-1. Pairing using SSP (Simple Secure Pairing) [Default]
(1) After turning the printer's power switch on, press and hold the PAIR button on the rear interface of the printer for 5
seconds or more, and then release it. The LED will flash green.
(2) Pairing will be possible for 60 seconds from when the LED begins flashing green.
During this time, perform pairing from the master device.
Device name: Star Micronics (default)
(3) After performing pairing, wait until the LED stops flashing green, or turn the printer off and back on again, to enable
the connection.
With some master devices, after pairing, the LED will automatically begin flashing blue, and the printer will be au-
tomatically connected.
(4) Connect to the printer from the master device application and perform printing. If the printing is successful, the
pairing process has been completed.
Note: The printer performs various processes immediately after connecting to or disconnecting from a master
device.
Please wait approximately 0.1 seconds after connecting, and approximately 0.5 seconds after disconnecting,
before beginning communications with the printer. This wait will ensure that the next action you perform
is executed correctly.
(For Bluetooth Interface Models only )
PAIR button
RST PAIR
< LED > Indicates the status of the Bluetooth interface.
Green (on): Not connected.
Green (flashing): Ready to start pairing.
Blue (on): Connected.
Purple (flashing): Auto connection enabled.
PAIR button
- 12 -