Solving Easymanagement Problems - Epson PowerLite 7850p User Manual

Solving Problems
182

Solving EasyManagement Problems

You don't see your projector in the EMP Monitor window.
■ Make sure that you've connected the projector to the network and
configured it correctly; see page 138 for information about setting
up the projector for a wired network, or page 70 for information
about setting it up for a wireless network. Also, make sure you've
registered the projector with EMP Monitor. See page 140.
Make sure that Standby Mode in the projector's Advanced 1
■
menu is set to
Network ON
If the computer you are using is running Windows XP or 2000,
■
you must be logged in as the Administrator.
Try restarting your computer.
■
You can't connect to the projector using NS Connection.
Make sure your projector and computer are configured correctly.
■
See page 70 (Ad Hoc mode) or page 76 (Access Point mode) or
details.
■ Make sure that you have sufficient wireless signal strength (above
50 per cent). See the documentation for your computer's network
card for details.
If the projector is configured for Access Point mode and you're
■
using DHCP, allow a minute or two for your IP address to appear
in the Switch network dialog box. Sometimes it takes the server a
little while to pick up the IP address.
Make sure the projector and computer are using the same ESSID.
■
■ If you are using a projector keyword, it changes each time you
turn the projector off and then on again, or remove and reinsert
the 802.11b wireless card. Check the projector's keyword on the
EasyMP Network screen and enter it at the prompt.
■ Try connecting using IP Connect Mode. See page 92 for
instructions.
■ Restart your computer.
.