Table of Contents
Advertisement
4.
The Disks item is highlighted, press <Enter> to select the hard disk
drives to configure as RAID. The following pop-up screen appears.
Port Drive Model
0 XXXXXXXXXXXX
1 XXXXXXXXXXXX
2 XXXXXXXXXXXX
3 XXXXXXXXXXXX
↑↓
↑↓]-Previous/Next
↑↓
↑↓
[↑↓
5.
Use the up/down arrow key to highlight the drive you want to set,
then press <Space> to select. A small triangle marks the selected
drive. Press <Enter> after completing your selection.
6.
When the S t r i p e S i z e
S t r i p e S i z e item is highlighted, press the up/down arrow
S t r i p e S i z e
S t r i p e S i z e
S t r i p e S i z e
key to select the stripe size for the RAID 5 array, then press <Enter>.
The available stripe size values range from 4 KB to 128 KB. The
default stripe size is 64 KB.
T I P : We recommend a lower stripe size for server systems, and a higher
T I P :
T I P :
T I P :
T I P :
stripe size for multimedia computer systems used mainly for audio and
video editing.
7.
Key in the RAID volume capacity that you want, then press <Enter>
when the C a p a c i t y
C a p a c i t y
C a p a c i t y item is highlighted. The default value indicates
C a p a c i t y
C a p a c i t y
the maximum allowed capacity.
8.
Press <Enter> when the C r e a t e V o l u m e
warning message appears.
Are you sure you want to create this volume? (Y/N):
9.
Press <Y> to create the RAID volume and return to the main menu or
<N> to go back to the Create Volume menu.
A S U S P 5 M T - M
A S U S P 5 M T - M
A S U S P 5 M T - M
A S U S P 5 M T - M
A S U S P 5 M T - M
[
SELECT DISKS
Serial #
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
Select 2 to 4 disks to use in creating the volume.
[SPACE]-Selects
C r e a t e V o l u m e item is highlighted. This
C r e a t e V o l u m e
C r e a t e V o l u m e
C r e a t e V o l u m e
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
]
Size Status
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
XX.XGB Non-RAID Disk
[ENTER]-Selection Complete
5 - 9
5 - 9
5 - 9
5 - 9
5 - 9
Advertisement
Table of Contents
