Advertisement
Tip: Each mixing cycle should be started at the lowest setting, and then increasing the speed at 10-second intervals, until the
intended mixer setting is reached. This ensures thorough mixing of the ingredients and, at the same time, prevents ingredients
from spilling.
Turbo setting
For short-term maximum mixer performance (7000 rpm), the turbo function can be activated at any time at all cooker or mixer
settings by pushing in and holding the selector switch. This function is also available with the selector switch in the 'Off' position ( ).
Tip: The turbo setting is very useful for chopping herbs. Simply activate the turbo function in short bursts, checking regularly, until
the herbs have reached the intended state. Please note that only dry herbs can be properly processed this way. We therefore
recommend that the herbs are thoroughly dried after washing.
Steam cooking
∙ Fill the mixing bowl with one litre of water and put the steaming assembly together as described in the section 'Steaming
assembly'.
∙ Put in the food to be steamed and fi t the lid.
∙ Use the timer to select the required steaming time and turn the selector switch anti-clockwise to the 120 ° setting.
Tip: While the steaming grid is best suited for gently cooking fi sh or meat, you can steam vegetables at the same time in the
steam tray. However, to cook the food in the grid insert properly, a suffi cient amount of steam is required. Therefore ensure, that
not all the openings in the steam try are blocked by food. Additional side-dishes (such as potatoes or noodles) may be steamed at
the same time in the mixing bowl, with water added up to the max marking.
Acoustic signals, eg programme end etc.
∙ To mark the end of a cooking or mixing cycle, or an improperly locked appliance or other errors, the unit will give acoustic signals.
∙ Once a cooking or mixing cycle has fi nished, always turn the selector switch to the 'Off' position ( ) fi rst before selecting a new
programme or operating time.
Power interruption
In the case of a power interruption while a programme is running, the display shows the error code EE03 and acoustic warning
signals are heard. Should this occur, fi rst switch the appliance off and turn the selector switch to the 'Off' position ( ). Then switch
on again and re-start the cooking or mixing programme.
Error codes - overview
EE01
The mixing bowl is incorrectly fi tted and the appliance is not yet securely locked.
→ Install the mixing bowl correctly and lock the appliance.
EE02
The mixing bowl lid is not fi tted properly and not locked.
→ Fit the lid correctly and lock the appliance.
EE03
The selector switch was not in its 'Off' position ( ) when the appliance was switched on. See also 'Power
interruption'.
→ Switch the appliance off, turn the selector switch to its 'Off' position ( ), and switch on again.
EE04
The temperature inside the mixing bowl is too high.
→ Switch the appliance off, turn the selector switch to its 'Off' position ( ) and allow the bowl to cool down. Put
ingredients or water into the bowl before switching on again.
EE05
The motor jams.
→ Switch the appliance off immediately and disconnect it from the mains. Check whether the blade inside the bowl is
blocked by ingredients. If so, remove the blockage, re-connect the appliance to the mains and switch on again. If the
error message persists, switch off immediately and contact our Customer Service.
12
Advertisement
