Bake Burners And Glow Bar Igniters; Bake Assist - GE C2S985 Technical Service Manual

Bake Assist

A bake assist element is used on all Café models
and some Profi le models. It is located in the lower
oven.
To remove the bake assist:
1. Remove the oven door. (See
2. Remove the rear cover. (See
3. Disconnect the 2 wires from the rear of the bake
assist.
Disconnect
4. Remove the four 1/4-in. hex-head screws and
the bake assist.
Bake Assist
Bake Assist
1 on each side.
.)
Oven Door Removal
.)
Rear Cover
Disconnect
– 56 –

Bake Burners and Glow Bar Igniters

To check the resistance of the bake burner glow bar
igniter on Café models, remove the rear cover. (See
.) The glow bar igniter has an approximate
Rear Cover
resistance value of 233 at room temperature.
An open measurement indicates an open valve
winding, bake igniter, or open wiring.
The resistance of the bake burner glow bar igniter
on Profi le and GE models can be checked on the
ERC. Place the control panel in the service position.
(See
Touch Panel and Electronic Range Control (ERC)
Check for the approximate resistance value of 228
. An open measurement indicates an open valve
winding, open bake igniter, or open wiring.
Upper Oven
To remove the bake burner and replace the glow
bar igniter:
1. Remove the oven door. (See
2. Remove the rear cover. (See
3. Remove the two 1/4-in. hex-head screws (1 on
each side) from the oven fl oor cover.
4. Grasp the oven fl oor slots, lift the rear of the
oven fl oor cover, then slide the cover forward
and remove it from the oven cavity.
.)
.)
Oven Door Removal
.)
Rear Cover
(Continued next page)