GE C2S985 Technical Service Manual page 28

6. Pull the fi ber barrier out of the control panel.
7. Slide the wire clips off the top of the control
panel.
Wire Clip
8. Disconnect 2 wiring harnesses.
Disconnect
9. Remove 2 Phillips-head screws from the top of
the control panel (1 not shown).
Wire Clip
Disconnect
– 28 –
10. Remove 2 Phillips-head screws and the 2 control
panel brackets (1 not shown).
Bracket
11. Turn the control panel over to expose the control
board bracket. Release the control board tabs
from the control panel and remove the control
panel from the range.
Tab
Control
Board
Bracket
Tab
12. Mark and disconnect the 15 wires and wiring
harnesses from the control board.
13. Remove the 4 Phillips-head screws from the
control board bracket.