Remaining Battery Charge Indication - Sanyo VPC-MZ1EX Instruction Manual

REMAINING BATTERY CHARGE INDICATION

When using the nickel metal hydride batteries, the remaining battery charge can be checked on
the LCD monitor. Make sure to check this indicator before capturing an image. For an indication of
the possible length of time for battery operation, see "Battery Operation" on page 136.
1
Set the main switch to Õ, and press the power button.
œ Set the selector dial to anything other than P or Ü.
2
Press the info button.
œ The Information Screen will appear and the batteries remaining charge indicator appears
in the lower right corner of the LCD monitor. (If any data is present, you can also check the
remaining battery charge at the Information Screen of the playback mode. See pages 39
and 40.)
ê ç and ç ë
œ
displayed.
Indicator
Information
Screen
é ç
ç è
ç ê
ç ë
Flashing
œ Due to the battery characteristics, when the ambient temperature is low,
early for an incorrect indication of the remaining charge. Also, depending on the conditions
of use of the digital camera or the ambient conditions (temperature, etc.), the indicated
remaining charge may change. Therefore, this indication can only be used as a general
approximation of the remaining charge.
To cancel the display, press the info button.
(flashing) will appear even when the Information Screen is not
When
Information
Screen is not
displayed
No indication Approx. full.
No indication Battery power is low.
ê ç
It will soon be impossible to capture or playback images.
If this icon flashes when the shutter button is pressed,
ë ç
images cannot be captured. If it flashes while editing a
video clip, the editing cannot be performed. Recharge the
Flashing batteries.
MONITOR OFF
Remaining charge
ç may appear è
44
English