Panasonic SC-HTB770 Operating Instructions Manual page 35

HDMI
This system does not operate correctly.
If the HDMI cable is connected to the wrong
terminal (HDMI IN or HDMI OUT), this system will
not operate correctly. Turn the main unit off,
disconnect the AC mains lead and reconnect the
HDMI cable(s). ( 25, 26)
VIERA Link related operations no longer
function properly.
≥ Check the VIERA Link setting on the connected
devices.
≥ Have you turned the VIERA Link settings off?
( 34)
≥ When the HDMI connections are changed,
after a power failure or after the AC mains lead
has been removed, VIERA Link operations may
not function properly.
jTurn on all the devices that are connected to
the TV with an HDMI cable and then turn the
TV on.
jTurn off the VIERA Link settings of the TV
and turn it on again. For details refer to the
operating instructions for the TV.
jWhile the main unit and the TV are
connected with the HDMI cable, turn on the
TV and then remove the main unit's AC
mains lead and reconnect it again.
The first few seconds of audio cannot be
heard when using the HDMI connection.
This may occur during DVD-Video chapter
playback. Change the digital audio output setting
on the connected device from "Bitstream" to
"PCM".
When operating an HDMI compatible device
of a different brand, the main unit reacts in an
unwanted manner.
HDAVI Control commands may use a different
signal depending on the brand of the device. In
this case, turn VIERA Link off. (
Pairing cannot be done.
Check the Bluetooth
The device cannot be connected.
≥ The pairing of the device was unsuccessful or
the registration has been replaced. Try pairing
the device again. (
≥ This system might be connected to a different
device. Disconnect the other device and try
pairing the device again.
The device is connected but audio cannot be
heard through this system.
For some built-in Bluetooth
the audio output to "SC-HTB770" manually. Read the
operating instructions for the device for details.
The sound is interrupted.
≥ The device is out of the 10 m communication range.
Bring the Bluetooth
≥ Remove any obstacle between the main unit
and the device.
≥ Other devices that use the 2.4 GHz frequency
band (wireless router, microwaves, cordless
phones, etc.) are interfering. Bring the
Bluetooth
distance it from the other devices.
≥ Select "MODE1" for stable communication. (
34)
Bluetooth
®
device condition.
®
28)
devices, you have to set
®
device closer to the main unit.
®
device closer to the main unit and
®
32)
35
RQT9849