Jeep Compass 2013 Owner's Manual page 348

Hide thumbs Also See for Compass 2013:
Table of Contents

Advertisement

346 STARTING AND OPERATING
WARNING!
• The Electronic Stability Control (ESC) cannot pre-
vent the natural laws of physics from acting on the
vehicle, nor can it increase the traction afforded by
prevailing road conditions.
• ESC cannot prevent accidents, including those re-
sulting from excessive speed in turns, driving on
very slippery surfaces, or hydroplaning.
• The capabilities of an ESC-equipped vehicle must
never be exploited in a reckless or dangerous
manner, which could jeopardize the user's safety or
the safety of others.
ESC Operating Modes
The ESC system has three available operating modes for
four–wheel drive equipped vehicles and two available
operating modes for two–wheel drive equipped vehicles.
Full On (Four-Wheel Drive Models) Or On
(Two-Wheel Drive Models)
This is the normal operating mode for ESC. Whenever
the vehicle is started the ESC system will be in this "On"
mode. This mode should be used for most driving
situations. ESC should only be turned to "Partial Off" or
"ESC Off" for specific reasons as noted below.
Partial Off (Four-Wheel Drive Models) Or On
(Two-Wheel Drive Models)
This mode is entered by momentarily pressing the "ESC
Off" switch. When in "Partial Off" mode, the TCS portion
of ESC, except for the "limited slip" feature described in
the TCS section, has been disabled and the "ESC
Activation/Malfunction Indicator Light" will be illumi-
nated. All other stability features of ESC function nor-
mally. This mode is intended to be used if the vehicle is
I n f o r m a t i o n P r o v i d e d b y :

Advertisement

Table of Contents
loading

Table of Contents