Flash Lights With Remote Key Lock/Unlock - Jeep Compass 2013 Owner's Manual

UNLOCK button to deactivate the Vehicle Security
Alarm.

Flash Lights With Remote Key Lock/Unlock

This feature will cause the turn signal lights to flash when
the doors are locked or unlocked with the RKE transmit-
ter. This feature can be turned on or turned off. To change
the current setting, proceed as follows:
• For vehicles equipped with the EVIC, refer to "Elec-
tronic Vehicle Information Center (EVIC)/Personal
Settings (Customer-Programmable Features)" in "Un-
derstanding Your Instrument Panel" for further infor-
mation.
• For vehicles not equipped with the EVIC, perform the
following steps:
1. Press and hold the UNLOCK button on a programmed
RKE transmitter for at least 4 seconds, but no longer
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
than 10 seconds. Then, press and hold the LOCK
button while still holding the UNLOCK button.
2. Release both buttons at the same time.
3. Test the feature while outside of the vehicle by press-
ing the LOCK/UNLOCK buttons on the RKE trans-
mitter with the ignition switch in the LOCK position
and the key removed.
4. Repeat these steps if you want to return this feature to
its previous setting.
NOTE: Pressing the LOCK button on the RKE transmit-
ter while you are in the vehicle will activate the Vehicle
Security Alarm. Opening a door with the Vehicle Security
Alarm activated will cause the alarm to sound. Press the
UNLOCK button to deactivate the Vehicle Security
Alarm.
I n f o r m a t i o n P r o v i d e d b y :
2