Operating Tips - Jeep Compass 2013 Owner's Manual

Hide thumbs Also See for Compass 2013:
Table of Contents

Advertisement

• Most of the time, when in Automatic Operation, you
can temporarily put the system into Recirculation
Mode by pressing the Recirculation button. However,
under certain conditions, while in Automatic Mode,
the system is blowing air out the defrost vents. When
these conditions are present, and the Recirculation
button is pressed, the indicator will flash and then turn
off. This tells you that you are unable to go into
Recirculation Mode at this time. If you would like the
system to go into Recirculation Mode, you must first
move the Mode knob to Panel, Bi-Level, Mix, or Floor
and then press the Recirculation button. This feature
reduces the possibility of window fogging.

Operating Tips

NOTE: Refer to the chart at the end of this section for
suggested control settings for various weather condi-
tions.
UNDERSTANDING YOUR INSTRUMENT PANEL 307
Summer Operation
The engine cooling system in air-conditioned vehicles
must be protected with a high-quality antifreeze coolant
to provide proper corrosion protection and to protect
against engine overheating. A solution of 50% ethylene
glycol antifreeze coolant and 50% water is recommended.
Refer to "Maintenance Procedures" in "Maintaining Your
Vehicle" for proper coolant selection.
Winter Operation
Use of the air Recirculation Mode during winter months
is not recommended because it may cause window
fogging.
Vacation Storage
Anytime you store your vehicle, or keep it out of service
(i.e., vacation) for two weeks or more, run the air
conditioning system at idle for about five minutes in the
fresh air and high blower settings. This will ensure
I n f o r m a t i o n P r o v i d e d b y :
4

Advertisement

Table of Contents
loading

Table of Contents