Dremel 3D20 Quick Start Manual page 5

5
Getting Ready to Build (continued...)
LEVELING BUILD PLATFORM
1. Tap "Tools" on your Dremel 3D20's touch screen and
tap "Level" .
2. First level the front left of the build platform.
3. Place the leveling sheet between the extruder and build
platform.
a) If the leveling sheet cannot slide between the extruder
and build platform, turn the knob counterclockwise until
you can slide the leveling sheet between the extruder and
build platform with some resistance.
b) If the leveling sheet can slide between the extruder and
build platform too easily, turn the knob clockwise until you
can slide the leveling sheet between the extruder and build
platform with some resistance.
4. Tap "Next" to move the build platform toward the right knob
and repeat step above.
5 Tap "Next" to move the build platform toward the rear knob
and repeat step above.
6. Tap "Finish" to complete the leveling process.
1
3
WARM
STEP 2: RIGHT ADJUSTMENT
NEXT
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
BACK
THE BUILD PLATFORM
4
WARM
STEP 1: LEFT ADJUSTMENT
NEXT
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
BACK
THE BUILD PLATFORM
2
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
WARM
STEP 3: BACK ADJUSTMENT
NEXT
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
BACK
THE BUILD PLATFORM
5