Honeywell CADVR-1004-WD-M User Manual page 34

Tip
: PPPoE dial-up successful, according to 【 PPPoE IP 】 shown on IP address, users can remote access
hard disk video recorder. By nic LAN IP access.
The dvr support model：
Unicom：huawei E173,zhongxing MF100
Telecom:huawei EC150.huawei EC156.zhongxing MF583
"3G DIAL" have two modes with automatic and manual dialing, the operation follows as below.
1. Automatic Dialing
Select the Automatic Dialing in the interface of the following picture, fill the right information according to the
operator where the 3G card belongs to and the 3G referred guide, It includes IPS names, AP, dial-telephone, ID and
password, the interface shows as the other following picture (some IPS once be chosen, the other relative
information has been already done, so you needn't fill any more, click "SAVE" directly). Then click "Save" directly.
After having detected the 3G signal when DVR start, the system will dial up automatically.
2. Manual Dialing
In the interface of following picture, users would fill the right information in the menu bar as same as
Automatic dialing and click "SAVE". Then click "Dial-up" after saving successfully (The referred information
would be saved still after the DVR restart, but you should click "Dial-up" again).
In these two modes, if the dial-up want success, first you should make sure that the 3G card is available. Since
the 3G signal has been existed, the related menu bar will show the correct IP address; if failed, system will pop up a
window to show the wrong information.
33