Tunturi GO 10 User Manual page 10

1. Increase the treadmill's speed to 5
km/h (3 mph).
2. Turn both adjustment screws an
equal amount, ¼turn clockwise.
3. Try to slow the belt down by holding
onto the handrails and braking as
you walk (as if you were walking
downhill). If the belt slips, turn
another 1/4 turn and repeat the test.
When braking heavily the belt may
slip. If the belt keeps slipping despite
repeated adjustments, please contact
your local Bremshey dealer.
MALFUNCTIONS
NOTE!
Despite continuous quality control,
defects and malfunctions caused by
individual components may occur
in the equipment. In most cases it's
unnecessary to take the whole device
in for repair, as it's usually suffi cient
to replace the defective part. Always
give the model, serial number of your
equipment and in case of malfunctions
also conditions of use, nature of
malfunction and any error code.
When you encounter unusual behavior
from the treadmill, simply turn the power
switch off, wait 1 minute and turn the
power switch on to reset the treadmill.
This should clear incidental errors and
ready the treadmill for normal operation
again. If after you have reset the
treadmill by turning the power switch off
and on again, and the treadmill is still not
operational, contact your local Bremshey
dealer for service.
If you require spare parts, always
give the model, serial number of your
equipment and the spare part number
for the part you need. The spare part list
is at the back of this manual. Use only
spare parts mentioned in the spare
part list.
O W N E R ' S M A N U A L • G O R U N 1 0 O W N E R ' S M A N U A L • G O R U N 1 0
ERROR CODES
The user interface will display
information about operational faults.
E1: SPEED SENSOR ERROR.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use the
treadmill. Otherwise, call the dealer
for service.
E6, E7: LIFT MOTOR ERROR.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use
the treadmill.
PROTECTIVE CIRCUIT
The machine will shut off when the
electricity load is above the machine's
capacity. To restart the machine, please
follow the procedure below:
1. Unplug the power cord from the
machine's socket.
2. Push in the safety switch.
3. Replug the power cord into the
machine's socket.
NOTE!
DON'T PUSH IN THE SAFETY
SWITCH BEFORE UNPLUGGING THE
MACHINE'S POWER CORD.
If you leave the treadmill plugged in
after turning off the console, there will
still be current running to the console.
This treadmill is equipped with a safety
control program that will automatically
shut down the machine after six hours of
no use. In the event of an automatic shut
down, please follow the procedure below
to restart the treadmill: A. Unplug the
power cord form the machine's socket.
G B
9