Baxi Combi 130 HE Installation & Servicing Instructions Manual page 23

Inner Flue Support Bracket
Flue Elbow
Fig. 25
Fig. 24
Flue
Gasket
Flue Trim
8.0 Installation
8.6 Fitting the Flue (Cont)
8. Ensure the inner flue support bracket is
positioned in the flue (Fig. 24).
9. Engage the flue into the flue elbow using
soap solution to ease the engagement ensuring
the flue is assembled as shown (Fig. 25).
10. Place the gasket over the flue exit on the
boiler (Fig. 25).
11. Slide the flue assembly through the hole in
the wall. Ensure angled inner end slopes
downwards (Fig. 26).
12. Engage the elbow on to the flue connection
on top of the boiler. Secure with the four screws
supplied in the kit.
13. Make good between the wall and air duct
outside the building ensuring the 3° drop
between the terminal and elbow.
14. The flue trim should be fitted once the
installation is complete and the flue secure
(Fig. 26). Making sure the brickwork is dust free
and dry apply a suitable mastic to the inside of
the trim and press against the wall finish,
15. If necessary fit a terminal guard (see
Section 7.9).
Only flues approved with the Baxi Combi 130
HE Boiler can be used.
For information on vertical flues consult the
Fig. 26
Baxi Combination Boilers Brochure or Notes
for Guidance supplied with the vertical flue
pack.
VERTICAL FLUEING
23