Converting To A Different Gas Type - Fisher & Paykel CG604DX Installation Instructions Manual

17

CONVERTING TO A DIFFERENT GAS TYPE

Important!
Gas conversion may only be carried out by a suitably qualified and registered person. To convert from one gas type to another you will need to replace the injectors and adjust the minimum burner setting.
Replacing the Injectors
ON
OFF
GAS
GAS
Switch off the power at the wall and
1
ensure the gas supply is shut off at the
connection point from the wall.
Reset the minimum setting
GAS
GAS
ON
ON
Switch on the power at the wall
5
and turn the gas supply on at the
connection point from the wall.
Replace the dial carefully. Ensure
8
the dial is in the o (off ) position.
Replace the pan supports.
Remove all pan supports and burners.
2
Low
Light the burner and set the dial to the
6
minimum (Low) setting.
Check the regulation by quickly turning down the flame from maximum to the minimum
9
setting – it must not go out. If the flame does go out, check the gas pressure has been
correctly set (step 11) then re-adjust the minimum setting following steps 6-9 above.
Auxiliary, rapid and semi-rapid burners
Unscrew the injectors and replace with the supplied injectors.
3
Auxiliary, rapid and semi-rapid burners wok burners have 1 injector.
Use a 7 mm box spanner.
Mini wok burner (CG604DX only) has 1 injector. Use a 7 mm ring spanner.
Wok burner (CG905DX only) has 3 injectors. Use a 7 mm ring spanner on two of them.
Pull off the Dial. Under the dial is a plastic bezel. Under this is a rubber gasket.
7
Carefully slide a 2.5 x 45mm Flat head screwdriver down the inside edge of the plastic bezel.
Gently push the rubber gasket aside to access the screw below (located in the "5 o' clock" position).
Rotate the screw slowly until a minimum regular flame is achieved.
Wok burner
Replace the burners.
4
Screw
Repeat for each burner.
Place the injector label over the existing 'gas type' label
located on the underside of the product.
9