Table of Contents
Advertisement
4. Insert the chiseled end of the jack handle at a
slight angle through the hole in the rear bumper
and into the funnel-shaped guide.
6-98
5. Turn the wheel wrench clockwise to raise the tire
part way up. Make sure the retainer is seated in
the wheel opening and the valve stem is
pointed down.
Continue raising the tire, watch to make sure it
does not get caught on anything on the underbody.
If the tire does get caught, loosen two or three
turns and push and pull the tire and then retighten.
Repeat this procedure as many times as needed to
ensure proper stowage.
6. When the tire is properly seated to the underbody,
continue turning the wheel wrench clockwise until
you hear two clicks or feel it skip twice. You cannot
overtighten the cable.
I n f o r ma t i o n P r o v i d e d b y :
Advertisement
Chapters
Table of Contents
