Bbq Grill (Option) - Jayco Eagle 264 BH Owner's Manual

Operation
Four spring loaded push button switches are located in the
center of panel. Press only one button at a time, as one set of
lights serve all functions. As you push any button, one or
more lights will come on, indicating the water level of that
tank.
When pushing the battery button, the highest light coming on
indicates battery condition. C=charging at 12.7 volts; G=good
at 11.9 volts; F=fair at 11.2 volts; and L=low at 6.0 volts.
The switch at the lower right is for water pump operation. In
the "ON" position, the pump runs until 45 pounds of pressure
has been achieved. The red light will stay on. Turn the switch
off when the pump is not in use.
The switch in the lower left corner is for direct spark ignition (D.S.I.) water heater
operation if the D.S.I. option is built into your travel trailer.
Fuses for the monitor panel operation are in 12-volt distribution center fuse block.
(Designer Model Option)
1. Press TEST spring loaded button to indi-
cate battery voltage and water level in
each tank.
2. Press PUMP button to turn water pump on
or off.
3. Press HEATER switch to turn water heater
on or off.

BBQ GRILL (Option)

WARNING: The maximum weight limit for the bracket on the side of your
travel trailer is 50 lbs. This limit includes the weight placed on the BBQ grill.
Exceeding this weight limit could cause damage to the unit and possibly cause
personal injury from hot equipment.
An option for your travel trailer is a BBQ Grill. This grill is for use outside of the travel
trailer and comes with a bracket to attach to the side of the unit. The following list will
supply basic operations for the grill. Be sure to read all instructions included with the
grill.
1. Install the grill bracket on the side of the travel trailer mounting bracket. Make sure
that it is securely in place.
2. Place the BBQ grill into the bracket. (Fig. 5-13)
3. Attach the fuel hose to the grill and the LP gas connection located under the travel
trailer by using the "Quick-Coupler" instruction as follows (Fig. 5-14):
• Place the handle in the "OFF" position and push back the sleeve. Valve handle
must be in the "OFF" position to make the connection. (Fig. 5-15)
• Insert the plug and release the sleeve. (Fig. 5-15)
74
Fig. 5-11
(Eagle/Qwest)
Fig. 5-12