Jayco Eagle 264 BH Owner's Manual page 47

6. After pumping all the chlorine solution into the tank, position the "Control Valves"
to the "City Fill" configuration. (Fig. 4-6)
7. Attach a garden hose to the "City Fill Connection" (Fig. 4-8) and finish filling the
tank.
8. Open kitchen and bathroom faucets to allow air to escape the water lines and the
water heater.
9. Turn the "Water Pump Switch" to the "ON" position and allow several seconds for
the pump to prime. (Fig. 4-7)
10. After the water heater and water lines fill, the air will stop bubbling out of the
faucets. At this point, turn all faucets off. Please note, the water heater will hold
approximately six gallons of water. Allow the water to run long enough to ensure
that the tank is full.
11. Allow to stand for three hours.
12. Drain the water tank and water heater completely by turning on all faucets until the
tank and water heater are empty.
13. With the garden hose connected to the "City Fill Connection" (Fig. 4-8), refill the
tank with fresh water as in steps 6 and 7.
14. Open kitchen and bathroom faucets to allow air to escape the water lines and the
water heater.
15. Turn the "Water Pump Switch" (Fig. 4-7) to the "ON" position and allow several
seconds for the pump to prime.
16. After the water heater and water lines fill, the air will stop bubbling out of the
faucets. At this point, turn all faucets off. Please note, the water heater will hold
approximately six gallons of water. Allow the water to run long enough to ensure
that the tank is full.
17. Allow to stand for at least three hours.
18. Drain the water tank and water heater completely by opening all faucets and low
point drains until tank and heater are empty.
To remove excess chlorine odor and taste:
1. In a large bucket, prepare a solution of 1/2 cup baking soda to one gallon (4 liters)
of water for every 15 gallons (60 liters) of tank capacity.
Repeat steps 3-10 from above.
2. Allow the baking soda solution to sit in the tank for a few days, if possible. If you
can have the soda in the tank while traveling, it will work better to clean and refresh
the tank from the agitating motion.
Repeat steps 12-18 from above.
3. Drain the water tank and water heater completely by turning all faucets on until the
tank and heater are empty.
36