Customising Using Type; Selecting Types - Meridian DSP5000C User Manual

Customising using Type

Type is a mode used specifically to restore the entire memory (except the
calibration memory) of DSP5000C to one of eight factory-preset
configurations. For all eight Types, Type resets the following:
phase to positive
axis to –1
balance to central (L 0)
tilt to 0.0
bass to 0.0
centre position to 1
speaker to left master or centre master (Type 6)
Depending on the Type selected, the other options are set as follows.
More information is given in Appendix 1, on page 52.
Type Application
1 500 mode, controller like 562
2 208 mode, with other Meridian
equipment in the system
3 201/601 mode, with other Meridian
equipment in the system
4 201/601 mode, with other Meridian
equipment in the system
5 500 mode, CD direct
6 500 mode, Meridian Digital Theatre
7 500 mode, Second room system
8 500 mode, Additional room system
When programming DSP5000C speakers, it is best to choose one of the
three standard Types as a starting point, and it may be possible to find
one that meets your needs exactly. Otherwise, choose the one that is
closest to your requirements. Select it, and set up the master/slave and
left/right speakers, by means of the following steps:

Selecting Types

1. Switch off the DSP5000C, using the power switch on the back, and
wait for 3 seconds
2. While pressing the 6 key (or 2 for Type 2, 5 for Type 5 etc.) on the
remote control, switch the power on again. The display will read
TY. #
where # is the Type you have selected.
3. Release the # key
After a couple of seconds, the display will change to
C.
This indicates that this speaker will be a centre master.
Customising using Config
D1 input
for
source
all
CD
all
CD
CD
all
all
all
DSP5000C User Guide
30
D2 input
for
source
na
others
na
others
others
na
na
na