Volume - Meridian DSP5000C User Manual

Dsp centre-channel loudspeaker
Hide thumbs Also See for DSP5000C:
Table of Contents

Advertisement

1
Here 1 is the number of the track currently playing on the disc.
If the disc includes significant index points, the display will be like this:
3.4
3.4 here means track 3, index point 4. In theory, with the right disc, we
could see displays of track and index up to 99.99. Index point 1 is never
displayed.
While the CD player is loading a disc (reading the disc's directory), the
DSP5000C will show the directory message:
dir
At the end of a CD, the DSP5000C will detect the lead-out track and
momentarily display the message
End
1. With the disc playing, press Display again. You will see a disc time
display, counting up as the disc plays.
2. Press Display again. You now have a display of time for the current
track only, also counting up as the disc plays.
3. Press Display again. The display should go blank on both master and
slave.
4. Pressing Display again brings you back to the source and volume
display.
One useful way to set up DSP5000C is to leave the track display on the
master, since the 565 or any slave always displays the source and
volume. If the CD player is in the same room, you can adjust its display to
give you additional time information.
Try pressing Display until you are familiar with its operation.
Other information reviewed in Standby
1. Press and hold Display
The display will show the version number of the microcontroller
software, followed by the currently-loaded DSP software. For example:
2.2
P1.81
d1.2
441b
Note The last DSP version number will depend on the operating mode of
the DSP5000C. The first two digits represent the sampling frequency;
DSP5000C automatically reloads a new program for each sampling rate.
The version numbers will also be different in Test and Calibrate.

Volume

To raise or lower the volume:
1. Press the upper or lower red key
The volume level displayed should count up or down, and will range from
1 to 99. Each step is precisely 1dB.
Note Subjectively one judges a volume increase of 9dB to be equivalent
to a doubling of loudness, so each volume number represents about a
11% change in loudness, with nine steps to double loudness.
Using DSP5000C
DSP5000C User Guide
16

Advertisement

Table of Contents
loading

Table of Contents