Meridian 565 Installation Manual page 25

565 standard settings
The following table shows the options configured by Types 0 to
5 on the digital surround processor:
Type Speakers
0 All analogue (Layout AG)
1 All analogue (Layout A)
2 All analogue (Layout A)
3 All Meridian DSP (Layout G)
4 Meridian DSP L, R, and Centre,
analogue surrounds (Layout G)
5 Meridian DSP centre,
otherwise analogue (Layout A)
Types 0 to 5 configure all the sources, except for CD, CDR, and
LD, to use the 565 analogue input. These are ideal for using the
565 on its own or with an analogue preamplifier, such as the
501/501V Control Unit.
A second set of six types, referred to as Type 0 562 to Type 5
562, are identical to Type 0 to 5 but configure all the sources
to use the 565 digital input. These are intended for use with a
562/562V Digital Control Unit.
If none of the standard settings exactly matches your
Mode
requirements choose the one that is closest, and then make the
500
necessary changes to the appropriate parameters as described
in the following sections of this chapter.
500
200
500
500
500
21