Enrolling Into "Z-Wave" Network - Trane 7CONT624AS42DA User's Manual And Installation Instructions

Enroll Comfort Control into existing Z-Wave Network
1
a. Power cycle the eMonitor Gateway (simple pull the plug and then plug it back in). This will leave the Gateway in
inclusion mode for 3 minutes to enable you to enroll the thermostat controls.
b. Alternatively if the eMonitor has already been registered, you can accomplish the same thing by going to
https://emonitor.us, clicking on Settings/Smart Controls, and pressing Add Control near the top of the page.
c. You can also put the Gateway into inclusion mode via the embedded web server.
2
Enroll the Comfort Control into the
a.
b Press
c.
d.
3
Verify enrollment of the Comfort Control.
a. Press Menu Button on the main Comfort Control screen.
b. Press the Next Button to advance to the About screen and press the Select Button.
c. Press the Next Button to advance through the menu options to Node ID
• If the number listed there is anything other than "00", the Comfort Control has been successfully enrolled.
• If the number listed there is "00", the Comfort Control has NOT been successfully enrolled. In this case, repeat step
verify again.
d. Press Done button 2 times when finished.
8
User Guide
. (Inclusion)
.
and