Main Menu - Panasonic PT-RZ12K Operating Instructions Manual

4) Press as to select a sub-menu, and press qw or the <ENTER> button to change or adjust settings.
f Some items will switch in order as follows each time you press qw.
f For some items, press qw to display an individual adjustment screen with a bar scale as shown below.
Note
f Pressing the <MENU> button while the menu screen is displayed returns to the previous menu.
f Depending on the signals to be input to the projector, some items or functions may not be adjusted or used. When the items cannot be
adjusted or used, the items in the menu screen are shown in black characters, and they cannot be adjusted or set. [DIGITAL CINEMA
REALITY] and [FRAME LOCK] may not be displayed depending on the input signal.
If the item in the menu screen is displayed in black characters and the item cannot be adjusted or set, the factor causing it is displayed by
pressing the <ENTER> button while the corresponding menu is selected.
f Some items can be adjusted even if signals are not input.
f Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.
f For menu items, refer to "Main menu" (x page 77) and "Sub-menu" (x page 78).
f The cursor color depends on the settings of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD DESIGN]. The selected
item is displayed with the yellow cursor by the factory default.
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu in portrait, go to the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] (x page 118) and change the
[OSD ROTATION] setting.
Resetting adjustment values to the factory default
If the <DEFAULT> button on the remote control is pressed, the values adjusted in the menu items are restored to
the factory default settings.
button
1) Press the <DEFAULT> button on the remote control.
Note
f You cannot reset all the settings to the factory default at a time.
f To reset all the settings adjusted in the sub-menu item to the factory default one at a time, execute the [PROJECTOR SETUP] menu →
[INITIALIZE] (x page 144).
f Some items cannot be reset to the factory default settings even when the <DEFAULT> button on the remote control is pressed. Adjust those
items individually.
f The triangular mark under the bar scale in the individual adjustment screen indicates the factory default setting. The position of the triangular
mark varies according to the selected input signals.

Main menu

The following items are in the main menu.
When a main menu item is selected, the screen changes to a sub-menu selection screen.
[PICTURE]
[POSITION]
[ADVANCED MENU]
Chapter 4 Settings — Menu navigation
A
CONTRAST
ADJUST
CONTRAST
ADJUST
Current adjustment value
Factory default setting
Main menu item
B C
0
0
Page
82
90
95
ENGLISH - 77