Panasonic PT-RZ12K Operating Instructions Manual page 122

4) Press qw to switch the item.
[ENABLE]
[DISABLE]
Note
f By closing the mechanical shutter, the malfunction of the DLP chip caused by high power laser ray entering the projection lens surface can
be prevented. To close the mechanical shutter, set [MECHANICAL SHUTTER] to [ENABLE] and then set the shutter function to be enabled
(shutter: closed).
f When [MECHANICAL SHUTTER] is set to [ENABLE], it will take approximately 0.5 seconds from when the shutter function is enabled
(shutter: closed) to the shutter function is disabled (shutter: opened).
f The light source may turn on darker to warm up when the shutter function is used when the operating environment temperature is around
0 °C (32 °F) when [MECHANICAL SHUTTER] is set to [DISABLE].
Setting [FADE-IN] or [FADE-OUT]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [FADE-IN] or [FADE-OUT].
4) Press qw to switch the item.
[FADE-IN]
[FADE-OUT]
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
4) Press qw to switch the item.
[OPEN]
[CLOSE]
Setting [SHUT-OFF]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[LAST USED]
122 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Turns off the light source and closes the mechanical shutter when the shutter function is enabled
(shutter: closed).
Leaves the mechanical shutter open and turns off only the light source when the shutter function is
enabled (shutter: closed).
Item
[OFF]
[0.5s] - [10.0s]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
The projector goes into standby mode with the condition of the mechanical shutter maintained when
the projector is switched off.
Adjustment
Does not set fade-in or fade-out.
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.