Panasonic PT-RZ12K Operating Instructions Manual page 23

The luminance can be maintained as much as possible for the same runtime by setting the [PROJECTOR
SETUP] menu → [OPERATION SETTING] → [CONSTANT MODE] to [AUTO]. These times are rough estimate
when the projector is used without changing the [OPERATING MODE] and [CONSTANT MODE] settings, and
will vary depending on individual difference and usage condition.
If brightness is noticeably reduced and the light source does not turn on, ask your dealer to clean inside the
projector or replace the light source unit.
rComputer and external device connections
f When connecting a computer or an external device, read this manual carefully regarding the use of power cords
and shielded cables as well.
rViewing 3D images
The projector can display the 3D video signal input in various formats such as "frame packing", "side by side", etc.
You are required to prepare external devices for viewing 3D images (such as 3D eyewear, video signal output
devices) which are suitable for your 3D system. Connections of the projector and external devices vary depends
on the 3D system to be used, see the operating instructions of external devices you use.
Refer to "List of 3D compatible signals" (x page 209) for the types of 3D video signals that can be used with the
projector.
Chapter 1 Preparation — Precautions for use
ENGLISH - 23